Bridge Media Converter []FT-802S50_10/100BASE-TX - 100BASE-FX

We offer a wide variety of products, and the following precautions apply to some of them. Please note that they are listed for all products. 【Voltage Compatibility】Designed for Japanese voltage (90-110V). Using with a different voltage may cause malfunction. 【Plug Type】Japanese plugs (A or B type). Use a conversion adapter if needed. 【Transformers & Adapters】Transformers adjust voltage; adapters only change plug shape. Using an adapter without a transformer may damage the product. 【Liability】We are not responsible for damages caused by improper use, such as using the product without a transformer. [Function] Compliant with IEEE 802.3, IEEE 802.3u 10/100BASE-TX, 100BASE-FX standards Connector: RJ45 (auto-MDI/MDI-X) twisted pair x 1, EIA568 optical fiber x 1, wavelength 1310 nm, connector type and distance vary depending on model. – FT-806A20 / FT-806A60: Tx-1310nm, Rx-1550nm – FT-806B20 / FT-806B60: Tx-1550nm, Rx-1310nm Data transfer rate: – TP: 10/100Mbps – Effect: 100Mbps Duplex mode support: – Full-duplex or half-duplex mode with auto-negotiation (TP) – Full-duplex or half-duplex mode with dip switch (FX) [Function 2] LED indicators: PWR, FX LNK/ACT, FX FDX/COL, TP 100, TP LNK/ACT, TP FDX/COL Dip switch: 2 dip switches – Rear dip switch: FX duplex mode selection – Side dip switch: LFP (Link Fault Pass-through) mode selection IEEE 802.3x Full duplex flow control and back pressure at half duplex eliminate packet loss. PLANET FT-80x is a Fast Ethernet bridge 100BASE-FX fiber to 10/100BASE-TX shielded twisted pair (STP) converter. It supports both half-duplex and full-duplex operation and a variety of fiber options. The converter automatically adapts to the highest level of performance supported by the device connected to the STP port. If the device is a switch or a workstation that supports full duplex, the converter will adapt to full duplex mode and provide an effective 200Mbps bandwidth. If the connected device is a hub or workstation that only supports half-duplex, the converter will adapt to half-duplex mode and provide a nominal 100Mbps bandwidth. The override switch provides complete manual control over half-duplex/full-duplex operation on fiber-optic interfaces. The converter's fiber port operates at 1310nm and uses ST, SC, MTRJ, VF45 or WDM connectors. A multi-mode model that supports distances up to 2km and a single-mode model that supports distances up to 15/20/35/50/60km are available. It is. The FT-80x series features LFP (Link Fault Pass-through function) (LLCF/LLR) and dip switch design. LLCF/LLR can instantly notify alarm administrators of link media problems and provide an efficient solution for monitoring the net. The DIP switch enables/disables the LFP function. LLCF (Link Loss Carry Forward) means that when a device is connected to a converter and the TP line loses the link, the converter's fiber breaks the link for transmission. LLR (Link Loss Return) means that if a device is connected to a converter and the fiber line loses link, the converter's fiber breaks the transmit link. Both can immediately notify alarm administrators of link media problems and provide an efficient solution for monitoring the net.