Warm infrared wall heater is designed for local additional heating of people and pets. This product is a long-lasting and cost-effective source of heat for health. Like the sun's rays, the heat of the infrared spectrum quickly heats not the air, but directly people and their pets located near the heater. That is, a person is warm, even if the room is cool. Soft infrared heat ionizes and purifies the air, does not burn oxygen and does not dry out the air.. An infrared heater is used in addition to the main heating of a room up to 5 m² (apartments, houses, industrial and administrative buildings). The heater can be used both in damp rooms and outdoors:
on the terrace,
in the garden house,
in the winter garden,
in a garage or small storage area.
Infrared heater - a silent, environmentally friendly and fireproof product. Does not cause burns in direct contact with skin. It is lightweight and can be stored and transported in a compact roll.
A bright picture-heater on the wall does not clutter up the room, gives positive emotions and useful warmth.
The painting's image is printed on innovative infrared electric PET film with a thickness of 0.08 cm. The film is durable and additionally laminated.
Operating principle of infrared film: electric current from a 220 V / 50 Hz network passes through a layer of graphite deposited on PET film. Graphite emits heat in the infrared spectrum, similar to solar heat.
The warm picture is equipped with a 220 V power cable, special profiles and a loop for wall mounting, as well as an overheat protection sensor. The overheating sensor is configured to limit the temperature of the painting surface within 50°C ± 5°C. The product is electrically safe: surfaces are laminated, live parts are carefully insulated.
SPECIFICATIONS
The size: 61 x 107 cm
Voltage: 220 V ± 22 / 50 Hz
Power: 300 W ± 50
Surface temperature 50 ± 5°C
Power cord length: 120 cm
Wall mount only
SAFETY REGULATIONS
ATTENTION! The wall-mounted photoheater is an electrical appliance that must be used with strict adherence to safety rules.
To prevent electric shock, the following must be observed::
Do not use the painting if the plug or wire of the electrical cord is damaged..
Do not connect the painting to the power supply earlier than 30 minutes after moving it from a cold to a warm room.
Do not turn on the picture heater when it is rolled up.
Do not use the painting in areas where it may be flooded or exposed to water or other conductive liquid..
Do not flood the painting with water or other electrically conductive liquids..
In case of contact with water or other electrically conductive liquids, do not use the painting until it is completely dry..
Do not bend a painting with a diameter smaller than the minimum allowable (10 cm). During use and storage of the painting, do not allow it to deform. (folds).
Do not apply significant point loads to the surface of the painting. (do not pierce, do not cut).
Do not leave the photoheater turned on unattended..
Do not cover the photoheater with foreign objects. Heat should escape freely.
Don't sleep/lie on a heater. For wall use only. The picture should be placed on a flat wall surface with the power cord facing down.
